Tangent Formers – Radius Corners

Tangent Formers
Home
Safes Electrical Enclosure
Boxes & Wireways
Furnace Wrapper Air-Conditioning Cabinets Radius Corners

Tangent Forming Radius Corners on Stainless Steel Oven Cavities

Oven Cavity MachineIntegrated Rollform, Tangent Form, & Welding Application PICTURE29Forming Unit with In-Line Welding
The System design is to Tangent Form the two ends and form the 1-1/2” radius corners. The Unit is completely automatic and programmed to produce a variety of three-sided “U” Shaped Housings and four-sided Full Wrapper Housings. Pre-punched and notched blanks are fed onto an Entry Conveyor which senses the length, width, and punch pattern variables. This information sets the width of the Rollformer and programs the forming sequence of the Tangent Former.

Because of the design, the System will make a wide range of “U” Shaped and Full Wrapper Housings. Sensing and automatic programming ensures the System produces a good part even when the Operator loads the wrong blank. A Rollformer is used to form the front and back outer edge flanges and adjust automatically for the width variable required.

Two Tangent Endformers form the 90° lead and trail ends of the Housings. Two Programmed Radius Tangent Forming Units form the 1-1/2” radius corners to produce the “U” Shape or four-sided Full Wrapper Housings. Full Wrapper Housings are then held and spot welded inline within the Tangent Forming Unit.

VIKING PART CLEAN 718 Ga. (.042) Stainless Steel
PICTURE27 See Video
Click Here

20 GA. Stainless Steel Full Wrapper Housing

See Video
Click Here

HOUSINGComplete Coil Fed Notch, Cutoff & Rollform System with Programmable Tangent Wingformer. The System designed to produce a wide variety of Stainless Housings with no setup or scrap loss. Daily production can be downloaded from an office computer based on height, width and quantities required. On-Time Production to feed complete Housing directly into the Weld Seam System. DogKennelCleanStainless Steel Kennel using a common coil strip width the System is designed to notch, punch and rollform and tangent form the 1/2” radius corners. Unit can produce a 48” x 72” Housing and 18” x 18” Housing without any setup or changeover.

Leave a Comment